Table of Contents
Advertisement
Command Reference Guide
ipv6 address <ipv6 address/prefix-length>
Use the ipv6 address command to assign a unicast Internet Protocol version 6 (IPv6) address to the
interface and enable IPv6 processing on the interface. Use the no form of this command to remove the
IPv6 address from the interface.
Syntax Description
<ipv6 address/prefix-length> Specifies the IPv6 unicast address to add to the interface. IPv6 prefixes
Default Values
By default, no IPv6 address is configured on the interface and IPv6 processing is not enabled on the
interface.
Command History
Release 18.1
Functional Notes
The IPv6 unicast address can be a global unicast address or a unique local address, but it cannot be a
link-local IPv6 address (FE80::). Link-local addresses are created on the interface using the command
ipv6 address <ipv6 link-local address> link-local on page
The address created by this command is a manually configured IPv6 address, which must have all parts
(prefix and host bits) specified.
Using the no form of this command with a specified IPv6 address removes only that IPv6 address from the
interface. Using the no form of this command without a specified IPv6 address removes all manually
configured IPv6 addresses from the interface.
Usage Examples
The following example adds a unicast IPv6 address to the interface and enables IPv6 processing on the
interface:
(config)#interface frame-relay 1.16
(config-fr 1.16)#ipv6 address 2001:DB8::/32
60000CRG0-35E
should be expressed in colon hexadecimal format (X:X::X/<Z>). For
example, 2001:DB8:3F::/64. The prefix length (<Z>) is an integer with a
value between 0 and 128.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Frame Relay Subinterface Command Set
2271.
2269
Advertisement
Table of Contents
