Table of Contents
Advertisement
Command Reference Guide
Frame Relay Subinterface Command Set
ipv6
Use the ipv6 command to enable Internet Protocol version 6 (IPv6) processing and create a link-local
address on an interface. Use the no form of this command to disable IPv6 processing and remove all IPv6
configuration on the interface.
Syntax Description
No subcommands.
Default Values
By default, IPv6 is not enabled on the interface.
Command History
Release 18.1
Command was introduced.
Functional Notes
Because AOS uses the dual-stack for IPv6 implementation, IPv6 features must be enabled for the
supported IPv6 features to be used. Enabling IPv6 in AOS is completed by using an IPv6 address or using
the ipv6 keyword with specific commands. For example, to enable IPv6 on an interface and cause the
interface to join the link scoped all-nodes and all-routers multicast group, enter an IPv6 address on the
interface.
Use the ipv6 command to enable IPv6 processing and create a link-local address on an interface when
other unicast IPv6 addresses are not needed on the interface. This command is not necessary nor
effectual when any other form of an IPv6 address command is also present on the interface.
Usage Examples
The following example enables IPv6 and creates a link-local IPv6 address on the interface:
(config)#interface frame-relay 1.16
(config-fr 1.16)#ipv6
60000CRG0-35E
Copyright © 2012 ADTRAN, Inc.
2266
Advertisement
Table of Contents
