Set-Overload-Bit - Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual

set-overload-bit

[ no ] set-overload-bit [ on-startup seconds | on-startup wait-for-bgp
Syntax
[ bgpSeconds ] ]
Command introduced before JUNOSe Release 7.1.0.
Release Information
Sets the overload bit, indicating to other IS-IS routers not to use this router as an
Description
intermediate hop in their SPF calculations. The no version restores the default value,
clearing the overload bit.
Options
Router Configuration
Mode
on-startup Sets the overload bit only after a system reload; prevents other
routers from routing through this router before it is fully operational
seconds Period after the reload during which the overload bit is set, in the range
5–86400 seconds; the overload bit is cleared when the period expires
wait-for-bgp Specifies that the overload bit is not cleared until BGP has
completed convergence
bgpSeconds Maximum period to wait for BGP to converge, in the range 5–86400
seconds with a default value of 600 seconds; the overload bit is cleared when
the period expires
Chapter 7: S Commands
501
set-overload-bit