Display Ipv6 Interface Tunnel - H3C S7500E Series Command Manual

Command Manual – IPv6 Configuration
H3C S7500E Series Ethernet Switches
Table 3-1 Description on fields of the display interface tunnel command
Tunnel1/0/3 current state: UP
Line protocol current state: UP
Description
Tunnel1/0/3 Interface
Maximum Transmit Unit
Encapsulation is TUNNEL
Aggregation ID
Tunnel source
Destination
Tunnel protocol/transport
Last 300 seconds input
Last 300 seconds output
packets input
input error
packets output
output error

3.1.4 display ipv6 interface tunnel

Syntax
display ipv6 interface tunnel number
View
Any view
Parameters
number: Tunnel interface number.
Field
3-4
Chapter 3 Tunneling Configuration Commands
Description
The physical layer protocol state of the tunnel
interface.
The link layer protocol state of the tunnel
interface.
Descriptive information of a tunnel interface
Tunnel interface number
Maximum transmission unit (MTU) in a tunnel
The encapsulation protocol is tunnel.
Link aggregation group ID referenced by a
tunnel. If the device supports link aggregation
groups, the link aggregation group ID configured
in tunnel interface view is displayed. If device
does not support, "aggregation ID not set" is
displayed.
Tunnel source address
Tunnel destination address
Tunnel protocol and transport protocol.
Number of bytes and packets input per second
in the last five minutes.
Number of bytes and packets output per second
in the last five minutes.
Total number of input packets.
Number of error packets among all input
packets.
Total number of output packets.
Number of error packets in all output packets