Show Ipv6 Route - Allied Telesis AT-IX5-28GPX Manual

IP 6 C
V OMMANDS
6
SHOW IPV ROUTE

show ipv6 route

Overview Use this command to display the IPv6 routing table for a protocol or from a
particular table.
For information on filtering and saving command output, see "Controlling "show"
Command Output" in the
and Configuration
Syntax
show ipv6 route
[connected|database|static|summary|<ipv6-address>|<ipv6-addr/p
refix-length>)]
Mode User Exec and Privileged Exec
Example 1 To display an IP route with all parameters turned on, use the following command:
awplus#
Output Figure 17-3: Example output of the show ipv6 route command
694 Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
Guide.
Parameter
connected
database
static
summary
<ipv6-address>
<ipv6-prefix/length> Displays only the routes for the specified IP prefix.
show ipv6 route
IPv6 Routing Table
Codes: C - connected, S - staticS
2001::a:0:0:c0a8:a6, vlan10
C 2001:db8::a:0:0:0:0/64 via ::, vlan10
C 2001:db8::14:0:0:0:0/64 via ::, vlan20
C 2001:db8::0:0:0:0/64 via ::, vlan30
C 2001:db8::28:0:0:0:0/64 via ::, vlan40
C 2001:db8::fa:0:0:0:0/64 via ::, vlan250
C 2001:db8::/64 via ::, vlan250
C 2001:db8::/64 via ::, vlan40
C 2001:db8::/64 via ::, vlan20
C 2001:db8::/64 via ::, vlan10
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
"Getting Started with AlliedWare Plus" Feature Overview
Description
Displays only the routes learned from connected
interfaces.
Displays only the IPv6 routing information extracted
from the database.
Displays only the IPv6 static routes you have configured.
Displays summary information from the IPv6 routing
table.
Displays the routes for the specified address in the IP
routing table. The IPv6 address uses the format
X:X::X:X/Prefix-Length. The prefix-length is usually set
between 0 and 64.
::/0 [1/0] via
C613-50057-01 REV A