Ethoam Vlan - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

Ethernet OAM Commands

ethoam vlan

Creates an association between Primary VID and Non-Primary VID(s).
ethoam vlan {vlanid-list} primary-vlan {vlan-id}
no ethoam vlan {vlanid-list}
Syntax Definitions
vlanid-list
vlan-id
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Each VLAN ID specified must be created before creating any association.
•
Each VLAN ID specified must be between 1 and 4094.
•
Each VLAN ID specified must be static.
•
A Non-Primary VID can only be associated with single Primary VID only.
•
Once Primary VID is associated with Non-Primary VID, then it can not be configured as Non-Primary
VID. Its association must be removed before it is configured as Non-Primary VID.
•
This CLI shall trigger Automip for this VLAN, if either 'mhf' is enabled for MA or default-MD with
primary VLAN same as the primary VLAN of this VLAN.
•
If the VLAN is deleted using VLAN CLI (no vlan <vid>) and VLAN is non-primary, then the entry for
this VLAN in the VLAN table will be deleted. This shall in turn delete all MEPs and MIPs associated
with it. If the deleted VLAN is primary VLAN, then all its associated VLAN entries in the VLAN table
shall be deleted. This shall in turn delete all MAs on this deleted VLAN.
•
Use the no form of this command to dissociate Primary VID from the Non-Primary VID(s).
Examples
-> ethoam vlan 10 primary-vlan 20
-> ethoam vlan 11-15 primary-vlan 20
-> ethoam vlan 30 40-50 primary-vlan 20
-> no ethoam vlan 10
Release History
Release 6.4.3; command was introduced
OmniSwitch CLI Reference Guide
VLAN Identifier List e.g. '10 30-40' or '10'
VLAN Identifier e.g. '20'
June 2012 page 45-3