Takeover - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

Alcatel-lucent omniswitch 6850-48: reference guide

Hide thumbs Also See for OmniSwitch 6850-48:

Table of Contents

takeover

The current secondary CMM assumes the role of primary CMM.

takeover [with-fabric]

Syntax Definitions

Platforms Supported

OmniSwitch 6400, 6850, 6850E, 6855, 9000E

Usage Guidelines

This command causes the secondary CMM to take over the functions of the primary CMM. After this

command, the old primary CMM is the new secondary CMM.

Before issuing the takeover command, be sure that the secondary CMM has all software (i.e., image

and configuration files) required to continue CMM operations.

For information on synchronizing the primary and secondary CMM software before issuing the

takeover command, see the

When the CMM modules switch primary and secondary roles, the console session to the new primary

CMM is disconnected. To continue managing the switch, be sure that you have physical connections to

both CMMs or local access to the switch in order to move your Ethernet or serial cable from one CMM

to the other.

The CPM, CFM and CPU of CMM can be reset independently.

If a takeover command is issued and the local/remote fabric module is in up state, only the CPM will

If a takeover command is issued and the local/remote fabric module is in a down state, then the

complete CMM will be reloaded.

This command can also be used on the secondary CMM.

If the switch is part of a stack with three or more switches, the next switch in "idle" mode becomes the

secondary CMM, and the original primary CMM becomes "idle." For more information on stacks, see

"Managing Stacks" in the Hardware Users Guide.

Note. The saved boot.cfg file will be overwritten if the takeover command is executed after the

command on an OmniSwitch set up with redundant CMMs. Refer to the

description on

ment modules.

Performs a complete CMM reload.

copy flash-synchro

for more information on the takeover command and redundant manage-

OmniSwitch CLI Reference Guide

CMM Commands

"NIs Reload On Take-