Saa Type Ip-Ping - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

saa type ip-ping

Configure SAA for IP including the number of packets and inter-packet delay parameters.
saa string type ip-ping destination-ip ipv4 addr source-ip ipv4 addr type-of-service tos [num-pkts
count] [inter-pkt-delay delay] [payload-size size]
Syntax Definitions
string
ipv4 addr
ipv4 addr
tos
count
delay
size
Defaults
parameter
count
delay
size
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
The num-pkts, inter-pkt-delay and payload-size are optional parameters. If these values are speci-
fied, the SAA is created with the values entered. If none of them are specified, the SAA is created with
the default values. The num-pkts and inter-pkt-delay can be modified, but payload-size cannot be
modified later.
•
The SAA must not be in a 'started' state at the time the num-pkts or inter-pkt-delay parameters are
modified. Make sure the SAA is stopped before attempting to modify these parameters.
•
The SAA must exist before issuing the CLI. If the SAA does not exist, the CLI will return an error.
•
Do not specify a broadcast or multicast address for the source or destination IP. In addition, do not use
0.0.0.0 as the destination IP address.
page 47-4
SAA ID string up to 32 characters. Use quotes around string if SAA ID
contains multiple words with spaces between them (e.g. "SAA 10").
The IPv4 address of the destination to ping.
The IPv4 address of the source.
The type of service.Valid range is 0 – 255.
The number of packets to send in one ping iteration.
Valid range is 1–10.
The delay between packets sent during a ping iteration, in milliseconds.
Valid range is from 100ms to 1000ms in multiples of 100ms.
The size of the ICMP payload to be used for the ping iteration. Valid
range is 24–1472 bytes.
default
5
1000ms
24 bytes
Service Assurance Agent Commands
OmniSwitch CLI Reference Guide June 2012