Show Service Sdp-Using - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show service sdp-using

Displays the Service Distribution Point (SDP) usage for the local router or for a far-end router IP address.
show service sdp-using [sdp-id[:vc-id] | far-end ip-address]
Syntax Definitions
sdp-id
vc-id
ip-address
Defaults
By default, a list of all associated SDPs configured for the switch is displayed.
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
•
Use the sdp-id parameter to display information for a specific SDP.
•
Use the far-end ip-addr parameter to display information about an SDP with a specific far-end
address.
Examples
-> show service sdp-using
SDP Using
SvcId SdpId
-----------+-------------------+-------+--------------+------+--------+--------
100 10:100
200 30:200
Number of SDPs : 2
-> show service sdp-using 10
Service Destination Point (Sdp Id : 10:0)
SvcId SdpId
-----------+-------------------+-------+--------------+------+--------+--------
100 10:100
Number of SDPs : 1
page 50-102
An existing SDP ID number.
A VC ID number used to validate the VC ID portion of each mesh SDP
binding defined for the service.
The system IP address for the far-end router. This is the user-configured
Loopback0 address if the far-end router is an OmniSwitch.
Type Far End
Mesh 10.11.0.6
Mesh 30.1.2.3
Type Far End
Mesh 10.11.0.6
Virtual Private LAN Service (VPLS) Commands
Opr I.Label
Up 131069
Down 0
Opr I.Label
Up 131069
OmniSwitch CLI Reference Guide
E.Label
131070
0
E.Label
131070
June 2012