Saa Stop - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

Service Assurance Agent Commands

saa stop

Stops the SAA test.
saa string stop [never | at yyyy-mm-dd,hh:mm:ss.ds]
Syntax Definitions
string
never
yyyy-mm-dd,hh:mm:ss.ds
Defaults
By default, the test is stopped immediately.
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
An existing SAA with the SAA type configured must be specified with this command.
•
The SAA must be in a 'started' state before giving the command unless the start and stop times are
scheduled. If the SAA is not in a 'started' state, the CLI will return an error.
•
Use the at option to specify a date and time for the test to stop.
•
If the never option is specified, the SAA test will keep on running until the saa stop command is
entered again with the at option.
•
If SAA test is stopped while it is running an iteration, the current iteration is pre-empted. The statistics
and history are updated for the partial iteration run.
•
If an SAA is scheduled to stop at a specified time and another saa stop command with a different value
is given before the specified time, the subsequent command will over-ride the previous command.
Examples
-> saa saa1 stop
-> saa saa2 stop never
Release History
Release 6.4.3; command was introduced.
OmniSwitch CLI Reference Guide
An existing SAA ID string.
Specifies that the SAA test will not be stopped unless the saa stop
command is used with the at option.
The date and time to stop the SAA test.
June 2012 page 47-13