Aaa Hic Server-Failure Policy User-Network-Profile Change - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

AAA Commands

aaa hic server-failure policy user-network-profile change

Configures which network profiles users will be moved to when both HIC servers are unavailable.
aaa hic server-failure policy user-network-profile change unp1 to unp2
aaa hic server-failure policy user-network-profile no change
Syntax Definitions
unp1
unp2
Defaults
parameter
change | no change
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855
Usage Guidelines
•
If the HIC failure mode is set to Hold and the HIC servers are not available this command allows users
in the HIC-in-progress state to be moved from unp1 to unp2. Once the HIC servers come back up, the
user shall be moved back to the original unp1 and the HIC-check will be restarted.
•
A maximum of 8 server-failure policies can be configured.
•
Use the no parameter to prevent users from moving out of their current UNP.
Examples
-> aaa hic server-failure policy user-network-profile change unp_orig to unp_temp
-> aaa hic server-failure policy user-network-profile no change
Release History
Release 6.4.4; command was introduced.
OmniSwitch CLI Reference Guide
Name of the original UNP from which the user will be moved if the
servers are not reachable and the failure mode is set to Hold.
Name of the UNP that the HIC host will be moved to while the HIC
servers are down.
default
no change
June 2012 page 36-93