Port-Security Shutdown - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

port-security shutdown

Configures the amount of time in minutes to allow source learning on all LPS ports. This LPS parameter
applies to the entire switch, so when the time limit expires, source learning of new MAC addresses is
stopped on all LPS ports. Only configured authorized MAC addresses are still allowed on LPS ports after
this timer expires. This command also enables or disables the conversion of dynamic MAC addresses to
static MAC addresses on LPS ports.
port-security shutdown num [convert-to-static {enable | disable}] [no-aging {enable | disable}] [boot-
up {enable | disable}]
Syntax Definitions
num
convert-to-static enable
convert-to-static disable
no-aging enable
no-aging disable
boot-up enable
boot-up disable
Defaults
By default, the LPS source learning time limit is not set for the switch.
parameter
convert-to-static
no-aging
boot-up
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
The LPS source learning time window is started and/or reset each time the port-security shutdown
command is issued or when the port-security shutdown boot-up option is enabled and the switch
restarts.
page 40-4
The number of minutes during which LPS allows source learning across
all LPS ports. This amount of time defines the LPS learning window.
Converts dynamically learned MAC addresses to static MAC addresses.
Dynamically learned MAC addresses are not converted to static MAC
addresses.
Prevents dynamically learned MAC addresses from aging out or getting
flushed during the LPS learning window time period.
Allows dynamically learned MAC addresses to age out or get flushed
during the LPS learning window time period.
Enables the automatic start of the LPS learning window timer when the
switch restarts.
Disables the start of the LPS learning window timer when the switch
restarts.
default
disable
disable
disable
Learned Port Security Commands
OmniSwitch CLI Reference Guide June 2012