Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 2438

-> show policy action a5
Action Name From
-----------+----+------+---+-----+---+---+---+---+---------+----+---+---+---
A5 cli
-> show applied policy action
Action Name From
-----------+----+------+---+-----+---+---+---+---+---------+----+---+---+---
A3 cli
A5 cli
A6 cli
action1 cli
action2 cli
-> show policy action action*
Action Name From
-----------+----+------+---+-----+---+---+---+---+---------+----+---+---+---
action1 cli
action2 cli
output definitions
Action Name
From
Disp
Pri
Share
Min Bandwidth
Max Bandwidth
Max Depth Bufs
Release History
Release 6.1; command was introduced.
Related Commands
policy action
page 33-218
Bandwidth
Disp Pri Share Min Max CIR PIR Max-Depth Bufs CBS PBS To
accept No
Bandwidth
Disp Pri Share Min Max CIR PIR Max-Depth Bufs CBS PBS To
accept No
accept No
accept No
accept No
accept No
Bandwidth
Disp Pri Share Min Max CIR PIR Max-Depth Bufs CBS PBS To
accept No
accept No
The name of the action, configured through the
mand.
Where the policy rule originated: cli indicates that the entry was config-
ured on the switch; ldap indicates the entry was configured through
PolicyView.
The disposition of the rule, either accept or deny.
The priority configured for the rule.
Whether or not the rule specifies that the queue should be shared.
The minimum bandwidth required by the rule.
The maximum bandwidth required by the rule.
Maximum depth (in Kbytes) of queues for traffic.
Creates a policy action. A QoS action is a particular set of bandwidth
and queue parameters that may be applied to a flow matching particular
QoS conditions.
10M 10M
10M
10M 10M
10M 20M
10M 20M
10M 20M
10M 20M
OmniSwitch CLI Reference Guide
QoS Policy Commands
Burst size
4K
Burst size
4K
4K
4K 40M
Burst size
4K
4K 40M
policy action com-
June 2012