Virtual Private LAN Service (VPLS) Commands
configure service vpls mesh-sdp ingress vc-label
Configures the static MPLS VC label used by the far-end router to send packets to this router using the
specified mesh SDP binding.
configure service vpls service-id mesh-sdp sdp-id[:vc-id] ingress vc-label ingress-vc-label
configure service vpls service-id no mesh-sdp sdp-id no ingress vc-label
Syntax Definitions
service-id
sdp-id
vc-id
vc-label
Defaults
By default, the ingress VC label value is set to zero (0).
parameter
vc-id
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
Use the no form of this command to remove the ingress VC label from the specified VPLS.
Examples
-> configure service vpls 100 mesh-sdp 20 ingress vc-label 131069
-> configure service vpls 100 mesh-sdp 20 ingress no vc-label
Release History
Release 6.4.2; command was introduced.
OmniSwitch CLI Reference Guide
An existing VPLS ID number.
An existing SDP ID number that is bound to the specified service ID
number.
A VC ID number used to validate the VC ID portion of each mesh SDP
binding defined for the service.
The ingress VC value that identifies a specific connection. The valid
range is 2048–18431.
default
service-id value
June 2012
page 50-47