Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 3127

MPLS LDP Commands
->show router ldp peer 10.11.0.6
LDP Peers
Peer
-----------------+----+----+-------+-------+-------+--------+---------+--------
10.11.0.6
No. of Peers: 1
->show router ldp peer 10.11.0.66 detail
LDP Peers (Detail)
Peer 10.11.0.66
Admin State:
Hold Time:
Keepalive Timeout:
Passive Mode:
Active Adjacencies:
Tunneling:
Lsp Name:
output definitions
Peer
Adm
Opr
Hello Factor
Hold Time
KA Factor
KA Timeout
Passive Mode
Auto Created
Last Modified
Active Adjacencies
OmniSwitch CLI Reference Guide
Adm Opr Hello Hold
Factor Time
Up Up 3 45
Up,
45,
40,
Disabled,
1,
Disabled,
None
The IP address of the LDP peer.
The administrative state of the LDP peer (Up or Down).
The operational state of the LDP peer (Up or Down).
The Hello factor value that is divided into the Hold Time value to
determine the interval at which Hello messages are sent. LDP uses
hello messages to discover neighbors and to detect loss of connectivity
with its neighbors.
The Hold Time value (also referred to as Hello Timeout) determines
the amount of time, in seconds, LDP waits to receive hello messages
from a peer before declaring that the peer is down.
The Keepalive Factor value that is divided into the Keepalive Timeout
value to determine the interval at which Keepalive messages are sent.
LDP keepalive messages are sent to keep the LDP session from timing
out when no other LDP traffic is sent between neighbors.
The amount of time, in seconds, LDP waits to receive keepalive mes-
sages from an LDP peer before tearing down the session with that peer.
Whether or not passive mode is active (True or False). When passive
mode is active, LDP responds only when a connect request is received
from a peer and does not actively try to connect with peers. When this
mode is not active, LDP actively tries to connect to peers.
Indicates if a targeted peer was automatically created through service
manager (Yes or No). This value is always No for an LDP interface.
The date and time the interface configuration was last modified.
The number of active adjacencies between this interface and LDP
peers.
June 2012
KA KA Passive
Factor Timeout Mode
4 40 Disabled
Oper State:
Hello Factor:
Keepalive Factor:
Last Modified: 05/26/2009 23:14:27,
d: Yes,
Auto
Created
Yes
Up,
3,
4,
page 48-71