Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 2521

802.1X Commands
output definitions (continued)
Supplicant Bypass allow-eap
Branch
Captive Portal Inactivity
Logout
Release History
Release 6.1; command was introduced.
Release 6.3.4; Captive Portal fields added.
Release 6.4.4; Supplicant Bypass, Supplicant Bypass allow-eap Branch, Captive Portal Inactivity
Logout fields added.
Related Commands
show 802.1x users
show 802.1x statistics
MIB Objects
dot1xAuthConfigTable
dot1xAuthAdminControlledDirections
dot1xAuthOperControlledDirections
dot1xAuthAuthControlledPortControl
dot1xAuthQuietPeriod
dot1xAuthTxPeriod
dot1xAuthSuppTimeout
dot1xAuthServerTimeout
dot1xAuthMaxReq
dot1xAuthReAuthPeriod
dot1xAuthReAuthEnabled
alaDot1xSuppPollingCnt
alaDot1xCPortalSessionLimit
alaDot1xCPortalRetryCnt
alaDot1xSupplicantBypass
alaDot1xSBAllowEAP
alaDot1xCPortalInactivityLogout
OmniSwitch CLI Reference Guide
Specifies the conditions under which subsequent 802.1x authentication
is attempted based on the outcome of the initial MAC authentication
(pass, fail, noauth, or none). Configured through the
plicant allow-eap command. This value only applies when Supplicant
Bypass is set to enable.
Whether or not a user MAC address is removed from the Captive Portal
user table when the same MAC ages out of the switch MAC address
table due to inactivity (enabled or disabled). Configured through the
802.1x captive-portal inactivity-logout
Displays information about users connected to the 802.1x port..
Displays 802.1x port statistics..
June 2012
802.1x non-sup-
command.
page 35-47