Ethoam Endpoint Lowest-Priority-Defect - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

Ethernet OAM Commands

ethoam endpoint lowest-priority-defect

Configures the lowest priority fault alarm for the lowest priority defect for a MEP.
ethoam endpoint mep_id domain {md_name | mac_address} association ma_name lowest-priority-
defect lowest_priority_defect
Syntax Definitions
mep_id
md_name
mac_address
ma_name
lowest_priority_defect
Defaults
parameter
lowest_priority_defect
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
The mep_id should be unique amid all those used by or available to the service provider in the specified
MA.
Examples
-> ethoam endpoint 100 domain esd.alcatel-lucent.com association alcatel-sales
lowest-priority-defect all-defect
Release History
Release 6.3.1; command was introduced.
OmniSwitch CLI Reference Guide
Specifies the Maintenance Association End Point. The valid range is
1–8191.
Specifies the domain name. For more information on the different
formats of the domain name, refer to
page 45-5.
Specifies the CFM system MAC address.
Name of the Ethernet OAM Association. Up to 48 (minus the domain
name length) characters may be used.
The lowest priority defect that can generate a Fault alarm. Possible
values are xcon, rem-err-xcon, no-defect, mac-rem-err-xcon, err-
xcon, and all-defect.
default
mac-rem-err-
xcon
June 2012
ethoam domain command on
page 45-35