Ethoam Fault-Alarm-Time - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

Ethernet OAM Commands

ethoam fault-alarm-time

Configures the timeout value for the Fault Notification Generation Alarm time that specifies the time
interval during which one or more defects should be detected before the fault alarm is issued.
ethoam fault-alarm-time centiseconds endpoint endpoint_id domain {md_name | mac_address}
association ma_name
no ethoam fault-alarm-time endpoint endpoint_id domain {md_name | mac_address}
association ma_name
Syntax Definitions
centiseconds
endpoint_id
md_name
ma_name
Defaults
parameter
centiseconds
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use the no form of this command to restore the Fault Notification Generation Alarm timeout value to
the default value.
•
The Fault Notification Generation Alarm timeout value is configurable per MEP.
Examples
-> ethoam fault-alarm-time 500 endpoint 100 domain esd.alcatel-lucent.com associa-
tion alcatel_sales
-> no ethoam fault-alarm-time endpoint 100 domain esd.alcatel-lucent.com associa-
tion alcatel_sales
Release History
Release 6.3.1; command was introduced.
OmniSwitch CLI Reference Guide
The Fault Notification Generation Alarm timeout value, in centi
seconds. The valid range is 250–1000.
Specifies the MEP of a specific MA. The valid range is 1–8191.
Specifies the domain name. For more information on the different
formats of the domain name, refer to
page 45-5.
Name of the Ethernet OAM Association. Up to 48 (minus the domain
name length) characters may be used.
default
250
June 2012
ethoam domain command on
page 45-41