Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 2546

ssl
no ssl
port
Defaults
Defaults for optional parameters are as follows:
parameter
port
retries
seconds
ssl | no ssl
Platforms Supported
OmniSwitch 6400, 6850,6850E, 6855, 9000E
Usage Guidelines
•
The dn_name must be different from the search_base name.
•
Use the no form of the command to remove an LDAP server from the configuration. Only one server
may be removed at a time. Note that if any Authenticated Switch Access (such as telnet) is configured
for the server, remove the switch access configuration first before attempting to remove the server.
•
The port number configured on the switch must match the port number configured for the server.
•
When communicating with the LDAP server, the Loopback0 address is used if configured, otherwise
the VLAN's IP address is used.
Examples
-> aaa ldap-server topanga5 host 10.10.3.4 dn cn=manager password tpub base c=us
retransmit 4
-> no aaa ldap-server topanga5
Release History
Release 6.1; command was introduced.
page 36-12
Enables a secure switch layer (SSL) between the switch and the LDAP
server.
Disables a secure switch layer (SSL) between the switch and the LDAP
server.
The port number for the primary LDAP server and any backup server.
Must match the port number configured on the server.
default
389 (SSL disabled)
636 (SSL enabled)
3
2
no ssl
OmniSwitch CLI Reference Guide
AAA Commands
June 2012