Show Service Id Sap - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

Virtual Private LAN Service (VPLS) Commands

show service id sap

Displays configuration information about the Service Access Points (SAPs) associated with the specified
service.
show service id service-id sap [slot/port | linkagg agg_num] [:0 | :all | :qtag1]
Syntax Definitions
service-id
slot/port1
agg_num
:0
:all
:qtag1
Defaults
By default, a list of all SAPs associated with the specified service ID is displayed.
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
To display detailed information for an individual SAP, specify a SAP ID using the slot/port and linkagg
agg-num parameters combined with the :0, :qtag, or :all parameters. For example, enter 1/2:all to display
information for the SAP on access port 1/2 that maps all traffic that is not classified into other SAPs to this
service.
Examples
-> show service id 100 sap
PortId SvcId
----------+------------+------+------+-------+-----
1/11:200 100
1/11:all 100
1/11:0 100
Number of SAPs : 3
OmniSwitch CLI Reference Guide
An existing VPLS ID number.
The slot and port number of the service access port.
The link aggregate ID number (0–31) of a service access link aggregate.
Specifies no (null) encapsulation value for the SAP. Depending on the
pre-configured encapsulation type for the access port, a SAP using a
null encapsulation will direct tagged and untagged or only untagged
traffic to the associated service.
Specifies a wildcard SAP. All 802.1q-tagged or untagged traffic that is
not classified into another SAP is mapped to the wildcard SAP. Not
configurable on null encapsulation access ports.
Specifies a VLAN ID tag for traffic ingressing on the access port. Only
traffic with this tag is mapped to this SAP. Not configurable on null
encapsulation access ports.
Adm Oper Trusted Pri
Up Up Yes
Up Up Yes
Down Down Yes
June 2012
0
0
0
page 50-93