Show Router Ldp Discovery Interface - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show router ldp discovery interface

Displays the discovery status of the LDP Hello adjacencies associated with the specified LDP interface.
show router ldp discovery interface ip-intf-name [state {trying | established | down}] [detail]
Syntax Definitions
ip-intf-name
trying
established
down
detail
Defaults
By default, this command displays the discovery status for all the LDP Hello adjacencies associated with
the specified interface.
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
•
Use the state parameter with the trying, established, or down options to display LDP adjacencies that
are in a specific state of discovery.
•
Use the detail parameter to display additional discovery information and statistics for the adjacencies.
Examples
->show router ldp discovery interface vlan-30
LDP Hello Adjacencies
Interface Name
--------------------------------+---------------+---------------+-------+------
vlan-30
No. of Hello Adjacencies: 1
->show router ldp discovery interface vlan-30 detail
LDP Hello Adjacencies (Detail)
Interface "vlan-30"
Local Address:
Adjacency Type:
Up Time:
Hello Mesg Recv:
Local IP Address:
Local Hello Timeout: 15,
Local Cfg Seq No:
page 48-60
The name of an existing LDP interface.
Displays adjacencies that the specified interface is trying to establish.
Displays established adjacencies for the specified interface.
Displays adjacencies for the specified interface that are down.
Displays detailed information about the LDP interface.
Local Addr
10.11.0.6
10.11.0.6,
Link,
0d 03:14:22,
2917,
30.30.30.66, Remote IP Address:
3,
Peer Addr
10.10.0.7
Peer Address:
State:
Hold Time Remaining:
Hello Mesg Sent:
Remote Hello Timeout: 15,
Remote Cfg Seq No:
OmniSwitch CLI Reference Guide
MPLS LDP Commands
AdjType State
Link Estab
10.10.0.7,
Established,
15,
2917,
30.30.30.77,
3
June 2012