Ethoam Linktrace - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

Ethernet OAM Commands

ethoam linktrace

Enables the maintenance entity to initiate transmitting Link Trace Messages (LTM).
ethoam linktrace {target-macaddress mac_address | target-endpoint t-mepid} source-endpoint s-
mepid domain {d-name | mac_add} association a-name [flag [fdb-mpdb | fdbonly]] [hop-count
hop_count]
Syntax Definitions
mac_add
t-mepid
s-mepid
d-name
domain mac_address
a-name
fdbonly
hop_count
Defaults
parameter
flag
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
This command allows an operator to generate a LTM for the specified MEP.
•
This command signals the MEP that it should transmit a Linktrace message and detect the presence or
lack of the corresponding Linktrace messages.
OmniSwitch CLI Reference Guide
Target MAC address to be transmitted.
Specifies the MEP for which the Loopback message is targeted.
Specifies the MEP that transmits the Loopback message. The valid
range is 1–8191.
Specifies the domain name. For more information on the different
formats of the domain name, refer to
Specifies the CFM system MAC address.
Name of the Ethernet OAM Association. Up to 48 (minus the domain
name length) characters may be used.
Specifies that only the MAC addresses learned in a bridge's active data
forwarding table will be used to decide the egress port.
Indicates the number of hops remaining in this LTM. Each bridge that
handles the LTM decreases the value by 1. This decreased value is
returned to the LTM. The valid range is 1–2^32.
default
fdbonly
June 2012
ethoam domain.
page 45-37