Configure Service Sdp Ldp - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

Virtual Private LAN Service (VPLS) Commands

configure service sdp ldp

Specifies LDP-signaled Label Switched Paths (LSPs) as the transport mechanism for the specified SDP
tunnel.
configure service sdp sdp-ip ldp
configure service sdp sdp-ip no ldp
Syntax Definitions
sdp-id
Defaults
By default, LDP-signaled LSPs are enabled for the SDP.
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
•
There are two types of LSPs: LDP and static. Assigning static LSPs or enabling LDP is required when
configuring a SDP. However, only one type of LSP per SDP is allowed.
•
Changing the LSP type is only allowed when the SDP is administratively disabled.
•
Use the no form of this command to specify the use of MPLS static LSPs instead of LDP-signaled
LSPs. This will turn off LDP signaling for the SDP so that using static LSPs is allowed.
•
Static LSPs are user-defined LSPs that require the manual configuration of MPLS label mappings and
actions on each participating router within the static path. A static LSP is associated with a SDP using
the configure service sdp lsp
Examples
-> configure service sdp 10 ldp
-> configure service sdp 10 no ldp
Release History
Release 6.4.2; command was introduced.
OmniSwitch CLI Reference Guide
An existing SDP ID number.
command.
June 2012 page 50-19