Show Loopback-Test - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show loopback-test

Displays the profile configuration for a hardware loopback test profile.
show loopback-test [profile_name]
Syntax Definitions
profile_name
Defaults
By default, all profiles are displayed if a profile name is not specified with this command.
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
Use the profile_name parameter to display the loopback test configuration for a specific profile.
Examples
-> show loopback-test
Profile-Name
----------------|-------------------|-------------------|------|-----|------+------
pro1
Total Entries = 1
output definitions
Profile Name
Src-Mac
Dest-Mac
Vlan
Port
Type
Status
Release History
Release 6.4.3; command was introduced.
page 44-52
The name of an existing hardware loopback test profile.
Src-Mac
00:d0:95:f3:63:58
The name of the loopback test profile.
The source MAC address of the test packet.
The destination MAC address of the test packet.
The VLAN ID of the loopback port.
The UNI or NNI loopback port.
The type of loopback test; Inward (ingress) or Outward (egress).
The status of the loopback test (Enable, Disable, or Config).
Dest-Mac
00:00:00:00:00:0a
OmniSwitch CLI Reference Guide
VLAN Stacking Commands
Vlan Port Type
100 6/1 Inward Start
June 2012
Status