48 Mpls Ldp Commands - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

48 MPLS LDP Commands

The LDP (Label Distribution Protocol) is used to set up Label Switched Paths (LSPs), also referred to as
Multiprotocol Label Switching (MPLS) tunnels. These tunnels are used to connect customer sites over a
service provider network and form the basis of any multipoint service, such as a Virtual Private LAN
Service (VPLS).
In addition to using LDP, configuring static LSPs is also supported. Both LDP and static LSPs provide the
label switching mechanism required by MPLS. For more information about static LSPs, see the "Static
LSP and FRR Commands" chapter in this guide.
MIB information for the LDP commands is as follows:
Filename: TIMETRA-LDP-MIB.mib
Module: TIMETRA-LDP-MIB
Filename: AlcatelIND1ServiceMgr.MIB
Module: Alcatel-IND1-SERVICE-MGR-MIB
A summary of the available commands is listed here:
Global Commands
Interface Commands
Targeted Session Commands
Graceful Restart Commands
LSP Ping and Traceroute
Commands
OmniSwitch CLI Reference Guide
configure router ldp shutdown
show router ldp parameters
show router ldp peer
show router ldp session
show router ldp status
configure router ldp interface-parameters interface
configure router ldp interface-parameters interface shutdown
configure router ldp interface-parameters hello
configure router ldp interface-parameters keepalive
configure router ldp interface-parameters transport-address
show router ldp interface
configure router ldp targeted-session hello
configure router ldp targeted-session keepalive
configure router ldp graceful-restart-helper
configure router ldp reconnect-time
configure router ldp fwd-state-holding-time
configure router ldp maximum-recovery-time
configure router ldp neighbor-liveness-time
oam lsp-ping
oam lsp-trace
June 2012 page 48-1