Ethoam Endpoint Admin-State - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

Ethernet OAM Commands

ethoam endpoint admin-state

Configures the administrative state of MEP.
ethoam endpoint mep_id domain {md_name | mac_address} association ma_name admin-state
{enable | disable}
Syntax Definitions
mep_id
md_name
mac_address
association_name
enable
disable
Defaults
The default value is disable.
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
The mep_id specified must already exist in the switch configuration.
Examples
-> ethoam endpoint 100 domain MD association MA admin-state enable
Release History
Release 6.2.1; command was introduced.
Release 6.3.1; mac_address parameter added.
OmniSwitch CLI Reference Guide
Specifies the Maintenance Association End Point. The valid range is
1–8191.
Specifies the domain name used while creating the management domain
for which this management association is created.
Specifies the CFM system MAC address.
Association name of the Ethernet OAM Association. Up to 48 (minus
the domain name length) characters may be used.
Administratively enables MEP.
Administratively disables MEP.
June 2012 page 45-27