Ethoam Endpoint - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

Ethernet OAM Commands

ethoam endpoint

Creates a Maintenance End Point (MEP) and virtual MEP.
ethoam endpoint mep-id domain md_name association ma_name direction { up | down } {port {slot/
port | virtual | linkagg agg_id} [primary-vlan vlan_id]
no ethoam endpoint mep-id domain md_name association ma_name
Syntax Definitions
mep_id
md_name
ma_name
up
down
slot/port
virtual
agg_id
vlan_id
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use the no form of this command to delete a maintenance endpoint.
•
The mep_id must be unique amid all those used by or available to the service provider in the specified
MA.
•
The direction for virtual MEP must always be up.
•
For creating a virtual MEP the value of port must be given the keyword "virtual".
OmniSwitch CLI Reference Guide
Specifies the Maintenance Association End Point. The valid range is
1–8191.
Specifies the domain name used while creating the management domain
for which this management association is created.
Association name for the created Ethernet OAM Association.
For UP MEP.
For DOWN MEP.
Physical slot and port number on which MEP needs to be created.
Keyword for creating virtual MEP.
Linkagg Identifier on which MEP needs to be created.
VLAN identifier.
June 2012 page 45-25