Virtual Private LAN Service (VPLS) Commands
configure service vpls create
Configures a Virtual Private LAN Service (VPLS) and associates that service with a customer account. A
VPLS connects multiple customer sites together across a provider-managed core network by creating a
virtual zero-hop, Layer 2 switched domain.
configure service vpls service-id customer customer-id create
configure service no vpls service-id
Syntax Definitions
service-id
customer-id
Defaults
N/A.
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
•
Use the no form of this command to remove the specified VPLS. Before attempting to remove the
VPLS, shutdown the administrative status of the service and shutdown and delete any Service Access
Points (SAPs) or Service Distribution Points (SDPs) associated with the service.
•
Creating more than one VPLS for a single customer ID is allowed. However, once a customer ID is
associated with a VPLS, changing the customer ID for that association is not allowed. If it is necessary
to make such a change, delete the VPLS and create the service again with the new customer ID.
•
Once a VPLS is created, it is then possible to bind the service to SAPs and SDPs.
•
Up to 1024 VPLS services are supported.
Examples
-> configure service vpls 10 customer 10 create
-> configure service no vpls 10
Release History
Release 6.4.2; command was introduced.
OmniSwitch CLI Reference Guide
A unique numerical value to associate with a specific VPLS. The valid
service ID range is 1–2147483647.
An existing customer ID number to associate with the specified service
ID number.
June 2012
page 50-29