Efm-Oam Errored-Frame-Period - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

Alcatel-lucent omniswitch 6850-48: reference guide

Hide thumbs Also See for OmniSwitch 6850-48:

Table of Contents

LINK OAM Commands

efm-oam errored-frame-period

Configures the threshold, window frame values and the status for notification when the number of frame-

errors exceed the threshold in a given period of time (specified) by window. When the number of frame

errors exceeds a threshold within a given window defined by a number of frames (for example, 10 frames

out of 1000 had errors), an Errored Frame Period event is generated.

efm-oam port slot/port[-port2] errored-frame-period [threshold threshold_symbols] [window

window_frames] [notify {enable | disable}]

Syntax Definitions

threshold_symbols

window_frames

threshold_symbols

enable | disable

The default for window_frames depends on the port-types. The default, minimum and maximum

supported values for various port-types are:

Platforms Supported

OmniSwitch 6400, 6850, 6850E, 6855.

OmniSwitch CLI Reference Guide

The slot number for the module and the physical port number on that

module (e.g. 3/1 specifies port 1 on slot 3).

The last port number in a range of ports that you want to configure on

the same slot. (e.g. 3/1-4 specifies ports 1,2,3 and 4 on slot 3).

Specifies the frame error threshold number. The range supported is 1 to

maximum 4 byte integer value (4294967295).

Specifies the number of frames used to define a window within which

the frame period errors are measured.

Enables notification of the Errored Frame Period event.

Disables notification of the Errored Frame Period event.

1 frame error

default value

minimum value

maximum value