Show Port-Security Shutdown - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show port-security shutdown

Displays the amount of time during which source learning can occur on all LPS ports.
show port-security shutdown
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
The source learning time limit is a switch-wide parameter that applies to all ports that have LPS
enabled.
•
If the shutdown time is set to 0, then a source learning time limit is not active on LPS ports.
•
Note that source learning of configured authorized MAC addresses is still allowed after the LPS time
limit has expired; however, all learning is stopped if the number of MAC addresses learned meets or
exceeds the maximum number of addresses allowed, even if the LPS time limit has not expired.
Examples
-> show port-security shutdown
LPS Shutdown Config
Convert-to-static
No Aging
Boot Up
Remaining Learning Window =
output definitions
LPS Shutdown Config
Convert-to-static
No Aging
Boot Up
Remaining Learning Window The remaining amount of time during which the LPS port can learn
page 40-24
= 25 min,
= DISABLE,
= ENABLE,
= ENABLE,
882 sec,
The configured amount of time during which the LPS port can learn
new MAC addresses.
Indicates whether or not dynamic MACs are converted to static MACs
(enabled or disabled).
Indicates whether or not learned MAC addresses can age out or get
flushed during the LPS learning window time period (disabled or
enabled).
Indicates whether or not the learning window automatically starts when
the switch boots up (enabled or disabled).
MAC addresses.
Learned Port Security Commands
OmniSwitch CLI Reference Guide June 2012