Show Ethoam One-Way-Delay - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

Alcatel-lucent omniswitch 6850-48: reference guide

Hide thumbs Also See for OmniSwitch 6850-48:

Table of Contents

Ethernet OAM Commands

show ethoam one-way-delay

Displays the one-way ETH-DM delay (latency) and jitter parameters either for all entries or for a speci-

fied MAC address for a particular source MEP-ID.

show ethoam one-way-delay domain domain association association endpoint s-mepid [mac-address

Syntax Definitions

Platforms Supported

OmniSwitch 6400, 6850, 6850E, 6855, 9000E

Usage Guidelines

Dash ('-') in the output in Jitter column signifies that the value can not be calculated as the previous

delay value is unknown. This will happen only when 1DM is received for the first time.

Maximum entries that Delay Result table can store are 1024. After that, the oldest entry is deleted from

the table whenever a new entry is required.

cli> show ethoam one-way-delay domain MD association MA endpoint 10

Legend: Jitter: - = undefined value

Remote Mac address

--------------------------+-------------+--------------------------------

00:d0:95:ef:44:44

00:d0:95:ef:66:88

00:d0:95:ef:88:88

00:d0:95:ef:66:55

cli> show ethoam one-way-delay domain MD association MA endpoint 10 mac-address

00:d0:95:ef:44:44

Legend: Jitter: - = undefined value

Remote Mac address

--------------------+-------------+-------------------

00:d0:95:ef:44:44

OmniSwitch CLI Reference Guide

Specifies the domain name used while creating the management domain

for which this management association is created.associationPhysical

slot and port.

Association name for the created Ethernet OAM Association.

Source MEP-ID. Vaild Range 1-8191.

MAC-Address of the remote MEP.