show router ldp bindings egress-label
Displays egress LDP bindings for a specific label number or for a range of label numbers.
show router ldp bindings egress-label start-label [end-label]
Syntax Definitions
start-label
end-label
Defaults
By default, all egress LDP bindings starting with the specified label number are displayed.
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
•
Use the optional end-label parameter along with the start-label parameter to specify a range of egress
label bindings to display.
•
If an ending label number is not specified, then all egress label bindings beginning with the starting
label number forward are displayed. No range is specified.
Examples
->show router ldp bindings egress-label 131071
LDP LSR ID: 10.11.0.6
Legend: U = Label In Use, N = Label Not In Use, W = Label Withdrawn,
S = Status Signaled Up,
R = VPRN Service, V = VPLS Service, W = VPWS Service
TLV = (Type, Length: Value)
LDP Prefix Bindings
Prefix
------------------+---------------+-------+------+-------------+---------------
10.10.0.7/32
No. of Prefix Bindings: 1
LDP Service FEC 128 Bindings
Type
VCId
------+----------+----------+------+---------------+-------+-------+-----+-----
No Matching Entries Found
LDP Service FEC 129 Bindings
AGI
page 48-42
The egress label number to display. The valid range is 16–1048575.
The last egress label number in a range of labels to display. The valid
range is 17–1048575.
D = Status Signaled Down,
Peer
IngLbl
10.10.0.7
--
SvcId
SDPId
Peer
SAII
EgrLbl EgrIntf
131071
--
IngLbl
EgrLbl
TAII
OmniSwitch CLI Reference Guide
MPLS LDP Commands
EgrNextHop
--
LMTU
RMTU
June 2012