Port-Security Learn-Trap-Threshold - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

port-security learn-trap-threshold

Configures the number of bridged MAC addresses to learn before sending a trap.
port-security slot/port[-port2] learn-trap-threshold num
Syntax Definitions
slot/port
-port2
num
Defaults
By default, the number of bridged MAC addresses learned is set to 5.
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
When the number of bridged MAC addresses learned on the port matches the specified threshold
amount, a trap is sent for every bridged MAC address learned thereafter.
•
Sending a trap when this threshold is reached provides notification of newly learned bridged MAC
addresses. Trap contents includes identifying information about the MAC, such as the address itself,
the corresponding IP address, switch identification, and the slot and port number on which the MAC
was learned.
Examples
-> port-security 1/10 learn-trap-threshold 6
-> port-security 1/10-13 learn-trap-threshold 18
Release History
Release 6.3.1; command was introduced.
Related Commands
show port-security
MIB Objects
learnedPortSecurityTable
lpsLearnTrapThreshold
page 40-20
The slot number for the module and the physical port number on that
module (e.g., 3/1 specifies port 1 on slot 3).
The last port number in a range of ports you want to configure on the
same slot (e.g, 3/1-4 specifies ports 1-4 on slot 3).
The number of bridged MAC addresses (1–100) to learn before sending
a trap.
Displays Learned Port Security (LPS) configuration and table entries.
Learned Port Security Commands
OmniSwitch CLI Reference Guide June 2012