Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 3042

•
When the target-endpoint parameter is specified and learned, two-way ETH-DM will transmit delay
measurement message (DMM) frames and delay measurement reply (DMR) frames whether or not the
RMEP state is OK.
•
The num-pkts and inter-pkt-delay parameters are optional. If these values are specified, the entry will
be created with those values. If none of them are specified, the SAA will be created with default values.
The num-pkts and inter-pkt-delay values can be modified, but the pkt-size value cannot be modified
later.
•
The SAA must not be in a 'started' state at the time the num-pkts or inter-pkt-delay parameters are
modified. Make sure the SAA is stopped before attempting to modify these parameters.
•
Target MEP/MAC, source MEP, domain, association and priority parameters are mandatory. If they are
not specified, the CLI will return an error.
•
The timeout for each DMM packet is one second. This value is not configurable.
Examples
-> saa saa1 type ethoam-two-way-delay target-endpoint 10 source endpoint 1 domain
md1 association ma1 vlan-priority 5
-> saa saa2 type ethoam-two-way-delay target-endpoint 10 source endpoint 2 domain
md1 association ma1 vlan-priority 5 num-pkts 6 inter-pkt-delay 500
-> saa saa3 type ethoam-two-way-delay target-endpoint 15 source endpoint 1 domain
md1 association ma1 vlan-priority 5 num-pkts 6
-> saa saa4 type ethoam-two-way-delay target-endpoint 10 source endpoint 2 domain
md1 association ma1 vlan-priority 5 inter-pkt-delay 500
Release History
Release 6.4.3; command was introduced.
Related Commands
show saa
show saa statistics
MIB Objects
alaSaaEthoamCtrlTable
alaSaaEthoamCtrlTestIndex
alaSaaEthoamCtrlRowStatus
alaSaaEthoamCtrlTestMode
alaSaaEthoamCtrlTgtMAC
alaSaaEthoamCtrlSrcMepId
alaSaaEthoamCtrlDomainName
alaSaaEthoamCtrlAssociationName
alaSaaEthoamCtrlNumPkts
alaSaaEthoamCtrlInterPktDelay
alaSaaEthoamCtrlVlanPriority
page 47-10
Displays SAA configuration information.
Displays SAA statistics.
Service Assurance Agent Commands
OmniSwitch CLI Reference Guide June 2012