Copy Running-Config Working - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

copy running-config working

Copies the running configuration (RAM) to the working directory.
[configure] copy running-config working
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
This command is used to copy the changes made using the CLI commands from the running
configuration (RAM) to the working directory.
•
This command is only valid if the switch is running from the working directory. Use the
running-directory
•
This command performs the same function as the
Note. The saved boot.cfg file will be overwritten if the
memory commands, in an OmniSwitch set up with redundant CMMs.
Examples
-> configure copy running-config working
Release History
Release 6.1; command was introduced.
page 53-8
command to check from where the switch is running.
write memory command.
takeover command is executed after the
OmniSwitch CLI Reference Guide
CMM Commands
show
write
June 2012