Vlan Specifications; Vlan Defaults - Alcatel-Lucent OmniSwitch 6850-48 Network Configuration Manual

VLAN Specifications

VLAN Specifications
Note that the maximum limit values provided in the following Specifications table are subject to available
system resources:
RFCs Supported
IEEE Standards Supported
Platforms Supported
Maximum VLANs per switch
Maximum VLAN port associations (VPA)
per switch
Maximum 802.1Q VLAN port associations
per switch
Maximum IP router interfaces per switch
Maximum IP router interfaces per VLAN
Maximum Spanning Tree VLANs per switch 252
Maximum IPX router interfaces per switch
Maximum authenticated VLANs per switch
MAC Router Mode Supported
CLI Command Prefix Recognition

VLAN Defaults

Parameter Description
VLAN identifier (VLAN ID)
VLAN administrative state
VLAN description
VLAN Spanning Tree state
VLAN mobile tag status
VLAN IP router interface
VLAN IPX router interface
VLAN authentication status
page 4-2
2674 - Definitions of Managed Objects for Bridges
with Traffic Classes, Multicast Filtering and Virtual
LAN Extensions
802.1Q - Virtual Bridged Local Area Networks
802.1D - Media Access Control Bridges
OmniSwitch 6400, 6800, 6850, 6855, and 9000
4094
32768
2500 (OmniSwitch 6400)
4094
128 IP (OmniSwitch 6400)
8
256
128
Single
All VLAN management commands support prefix
recognition. See the "Using the CLI" chapter in the
OmniSwitch AOS Release 6 Switch Management
Guide for more information.
Command
vlan
vlan
vlan name
vlan stp
vlan mobile-tag
ip interface
vlan router ipx
vlan authentication
OmniSwitch AOS Release 6 Network Configuration Guide
Configuring VLANs
Default
VLAN 1 predefined on each
switch.
Enabled
VLAN identifier (VLAN ID)
Enabled (Disabled if VLAN
count exceeds 254)
Disabled
VLAN 1 router interface.
No router interface defined.
Disabled
September 2009