LINK OAM Commands
efm-oam port remote-loopback
Specifies whether loopback requests from peers are processed or ignored on the specified port.
efm-oam port slot/port[-port2] remote-loopback {process | ignore}
Syntax Definitions
slot/port
-port2
process
ignore
Defaults
By default, the incoming loopback requests are ignored.
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855.
Usage Guidelines
•
When the remote-loopback is in process mode, the session started by peer LINK OAM client will be
processed by local LINK OAM port. As a result, remote port will be in remote-loopback state and the
local port will be local-loopback state.
•
When the remote-loopback is in ignore mode, the session started by peer LINK OAM will not be
processed by the local port.
Examples
-> efm-oam port 1/1 remote-loopback process
-> efm-oam port 1/1 remote-loopback ignore
-> efm-oam port 2/1-10 remote-loopback process
-> efm-oam port 2/1-4 remote-loopback ignore
Release History
Release 6.4.2; command was introduced.
OmniSwitch CLI Reference Guide
The slot number for the module and the physical port number on that
module (e.g. 3/1 specifies port 1 on slot 3).
Specifies the last port in the range of ports.
Processes incoming loopback request from peer LINK OAM port.
Ignore (discard) incoming loopback requests.
June 2012
page 46-11