Platforms Supported
OmniSwitch 9000E
Usage Guidelines
•
Use the no form of this command to delete a Layer 2 profile. Removing the def-access-profile is not
allowed.
•
Remove any profile associations with access ports before attempting to modify or delete the profile.
•
Not all of the protocol parameters are currently supported with the peer, tunnel, and discard parame-
ters. Use the following table to determine the parameter combinations that are supported:
stp
802.1x
802.1ab
802.3ad
gvrp
mvrp
amap
•
If a user-configured Layer 2 profile is not associated with an access port, then the def-access-profile is
used to process control packets ingressing on the port.
Examples
-> configure service l2profile "sap_1_profile" create stp discard
-> configure service l2profile "sap_1_profile" gvrp discard
-> configure service no l2profile "sap_1_profile"
Release History
Release 6.4.2; command was introduced.
Release 6.4.3; mvrp parameter added.
Related Commands
configure service port mode
access
configure service port l2profile
show service l2profile
page 50-52
peer
discard
no
yes
no
yes
no
yes
yes
no
no
yes
no
yes
no
yes
Configures a switch port or link aggregate as an access port.
Assigns a Layer 2 profile to the specified service access port.
Displays the Layer 2 profile configuration information for the router..
Virtual Private LAN Service (VPLS) Commands
tunnel
yes
yes
yes
no
yes
yes
no
OmniSwitch CLI Reference Guide
June 2012