Port-Security Mac-Range - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

port-security mac-range

Configures a list of authorized MAC addresses by defining a range of addresses allowed on the port. This
command also enables LPS on the specified port, if LPS is not already active on the port.
port-security slot/port[-port2] mac-range [low mac_address | high mac_address]
Syntax Definitions
slot/port
-port2
low mac_address
high mac_address
Defaults
parameter
high mac_address
low mac_address
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
If low and high end MAC addresses are not specified with this command, then the range is set back to
the default range value (00:00:00:00:00:00– ff:ff:ff:ff:ff:ff).
•
Source MAC addresses received on an LPS port that fall within the authorized range are allowed on the
port. An additional entry is made in the LPS table for each of these learned addresses.
•
Any additional source MAC addresses received that do not match configured authorized addresses are
allowed on the port based on the LPS time limit (if active) and the maximum number of MAC
addresses allowed.
•
Each configured authorized MAC address counts towards the number of addresses allowed on the port
even if the port has not learned the configured address. For example, if a port has 3 configured autho-
rized MAC addresses and the maximum number of addresses allowed is set to 10, then only 7 addi-
tional MAC addresses are allowed on that port.
page 40-14
The slot number for the module and the physical port number on that
module (e.g., 3/1 specifies port 1 on slot 3).
The last port number in a range of ports you want to configure on the
same slot (e.g, 3/1-4 specifies ports 1-4 on slot 3).
MAC address that defines the low end of a range of MACs
(e.g., 00:20:95:00:10:2A).
MAC address that defines the high end of a range of MACs
(e.g., 00:20:95:00:10:2F).
default
ff:ff:ff:ff:ff:ff
00:00:00:00:00:00
Learned Port Security Commands
OmniSwitch CLI Reference Guide June 2012