Configure Service Vpls Send-Flush-On-Failure - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

Virtual Private LAN Service (VPLS) Commands

configure service vpls send-flush-on-failure

Enables or disables the sending of a MAC flush message when a port or Service Access Point (SAP) asso-
ciated with the VPLS goes down.
configure service vpls service-id [customer customer-id] send-flush-on-failure
configure service no vpls service-id [customer customer-id] no send-flush-on-failure
Syntax Definitions
service-id
customer-id
Defaults
By default, the sending of a MAC flush message on failure is disabled.
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
•
Use the no form of this command to disable sending of MAC flush messages.
•
Specifying the customer ID associated with this VPLS is not required when using this command.
However, if the customer ID specified is not the one associated with the VPLS, the command is not
allowed.
•
This functionality provides an LDP-based mechanism for recovering a physical link failure in a dual-
homed connection to a VPLS service.
Examples
-> configure service vpls 10 send-flush-on-failure
-> configure service vpls 10 customer 10 send-flush-on-failure
-> configure service vpls 10 no send-flush-on-failure
Release History
Release 6.4.2; command was introduced.
OmniSwitch CLI Reference Guide
An existing VPLS ID number.
Optional. A customer ID number associated with the specified service
ID number.
June 2012 page 50-37