Efm-Oam Port Status - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

efm-oam port status

Enables or disables LINK OAM protocol on the specified port or on a range of ports.
efm-oam port slot/port [-port2] status {enable | disable}
Syntax Definitions
slot/port
-port2
enable
disable
Defaults
By default, the LINK OAM protocol is disabled on all ports for the switch.
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855
Usage Guidelines
•
LINK OAM must be enabled globally for the OAM to be functional on all the ports.
•
If LINK OAM is disabled for the port or globally disabled for the switch, any OAMPDUs received are
discarded.
•
When LINK OAM is disabled for the port, all dynamically learned information on the port, including
peer information, is deleted. However, the LINK OAM configuration for the port is retained.
•
LINK OAM is not supported on the mirroring ports.
•
In link aggregates, LINK OAM is supported on an individual aggregable port only.
Examples
-> efm-oam port 1/1 status enable
-> efm-oam port 1/1 status disable
-> efm-oam port 2/1-10 status enable
-> efm-oam port 2/1-4 status disable
Release History
Release 6.4.2; command was introduced.
page 46-4
The slot number of the module and the physical port number on that
module.
Specifies the last port in the range of ports.
Enables LINK OAM protocol on the specified port.
Disables LINK OAM protocol on the specified port.
LINK OAM Commands
OmniSwitch CLI Reference Guide June 2012