Configure Service Vpls Sap Trusted - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

Alcatel-lucent omniswitch 6850-48: reference guide

Hide thumbs Also See for OmniSwitch 6850-48:

Table of Contents

configure service vpls sap trusted

Configures the trust mode for the specified Service Access Port (SAP) ID. A SAP ID is comprised of a

customer-facing port (referred to as an access port) and an encapsulation value that is used to identify the

type of customer traffic to map to the associated service.

A trusted SAP can accept 802.1p values in incoming packets; an untrusted SAP will set any 802.1p values

to zero in incoming packets, unless an 802.1p value is configured with this command.

configure service vpls service-id sap {slot/port | linkagg agg_num} [:0 | :all | :qtag1] trusted

configure service vpls service-id sap {slot/port | linkagg agg_num} [:0 | :all | :qtag1] no trusted

priority value

Syntax Definitions

By default, the SAP is trusted with the priority set to best effort (zero). These default values are set when a

port is configured as an access port and then associated with the SAP.

:0 | :all | :qtag1

Platforms Supported

OmniSwitch 9000E

An existing VPLS ID number.

The slot and port number of the service access port.

The link aggregate ID number (0–31) of a service access link aggregate.

Specifies a null encapsulation value for the SAP. Depending on the pre-

configured encapsulation type for the access port, a SAP using a null

encapsulation will direct tagged and untagged or only untagged traffic to

the associated service.

Specifies a wildcard SAP. All tagged or untagged traffic that is not clas-

sified into another SAP is mapped to the wildcard SAP. Not config-

urable on null encapsulation access ports.

Specifies a VLAN ID tag for traffic ingressing on the access port. Only

traffic with this tag is mapped to this SAP. Not configurable on null

encapsulation access ports.

Allows the SAP to use the priority value obtained from tagged packets

ingressing on the SAP port. Untagged packets use the default port prior-

The priority value to set. Values range from 0 (lowest priority) to 7

(highest priority). This is the priority assigned to tagged and untagged

packets ingressing on an untrusted SAP.

Virtual Private LAN Service (VPLS) Commands

OmniSwitch CLI Reference Guide