Configure Service Port Mode Access - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

configure service port mode access

Configures a switch port or link aggregate as an access port for customer traffic.
configure service port {slot/port | linkagg agg_num} mode access
configure service port {slot/port | linkagg agg_num} no mode
Syntax Definitions
slot/port1
agg_num
Defaults
By default, switch ports and link aggregates are classified as network ports.
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
•
Use the no form of this command to revert the port mode back to the default mode (network).
•
Access ports are required to configure a Service Access Point (SAP). A SAP is the point at which
customer traffic enters and exits the provider service. SAPs are not configured on network ports
Examples
-> configure service port 1/3 mode access
-> configure service port linkagg 10 mode access
-> configure service port 1/3 no mode
-> configure service port linkagg 10 no mode
Release History
Release 6.4.2; command was introduced.
page 50-54
The slot number for the module and the physical port number on that
module (e.g., 3/1 specifies port 1 on slot 3).
The link aggregate ID number (0–31).
Virtual Private LAN Service (VPLS) Commands
OmniSwitch CLI Reference Guide June 2012