Show Service Id Sdp - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show service id sdp

Displays configuration information for the Service Distribution Points (SDPs) associated with the speci-
fied service.
show service id service-id sdp [sdp-id[:vc-id] | far-end ip-address] [detail]
Syntax Definitions
service-id
sdp-id
vc-id
ip-address
detail
Defaults
By default, a list of all SDPs associated with the specified service ID is displayed.
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
•
Use the sdp-id parameter to display information for a specific SDP.
•
Use the far-end ip-addr parameter to display information about an SDP with a specific far-end
address.
•
Use the detail parameter to display additional information about the SDPs.
Examples
-> show service id 100 sdp
Services: Service Destination Points
SdpId
----------------+----+---------------+-------+---------+-----------+-----------
10:100
Number of SDPs : 1
-> show service id 100 sdp detail
Services: Service Destination Points Details
Sdp Id 10:100
SDP Id:
page 50-96
An existing VPLS ID number.
An existing SDP ID number.
A VC ID number used to validate the VC ID portion of each mesh SDP
binding defined for the service.
The system IP address for the far-end router. This is the user-configured
Loopback0 address if the far-end router is an OmniSwitch.
Displays detailed SDP information.
Type IP address
Mesh 10.11.0.6
-(10.11.0.6)
10:100,
Virtual Private LAN Service (VPLS) Commands
Adm Opr I.Lbl
Up Up 131069
Type:
OmniSwitch CLI Reference Guide
E.Lbl
131070
Mesh,
June 2012