Show Vlan Port Mobile - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

Port Mobility Commands

show vlan port mobile

Displays current status of mobile properties for a switch port.
show vlan port mobile [slot/port]
Syntax Definitions
slot/port
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
If a slot/port is not specified, then mobile properties for all ports are displayed.
•
Note that the show vlan port mobile command only displays ports that are mobile or are eligible to
become mobile ports. For example, ports that are part of a link aggregate or are configured for 802.1Q
VLAN tagging are not included in the output of this command.
Examples
-> show vlan port mobile
cfg
port mobile def
+-----+------+----+--------+--------+--------+-----+
12/12 on 1
12/13 off
12/14 off
12/15 on 10
12/16 on 10
output definitions
port
mobile
cfg def
OmniSwitch CLI Reference Guide
The slot number for the module and the physical port number on that
module (e.g., 3/1 specifies port 1 on slot 3). To enter multiple slots and
ports in a single command, use a hyphen to specify a range of ports
(e.g., 3/1-16) and a space to specify multiple slots (e.g., 3/1-16 5/10-20
8/2-9).
authent enabled restore
off on
on-avlan off
on-8021x on
The slot number for the module and the physical mobile port number
on that module.
The mobile status for the port (on or off). If set to on, the port is mobile
and eligible for dynamic VLAN assignment. If set to off, the port is
non-mobile and remains only a member of its configured default
VLAN. Use the
port.
The configured default VLAN for the port, which is assigned using the
vlan port default
June 2012
ignore
bpdu
off off
on off
off on
vlan port mobile to enable or disable mobility on a
command.
page 37-39