Configure Service Sdp Create - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

Alcatel-lucent omniswitch 6850-48: reference guide

Hide thumbs Also See for OmniSwitch 6850-48:

Table of Contents

Virtual Private LAN Service (VPLS) Commands

configure service sdp create

Configures a Service Distribution Point (SDP). An SDP is a logical entity that directs traffic to another

router through MPLS-based service tunnels.

configure service sdp sdp-id [mpls] create

configure service no sdp sdp-id

Syntax Definitions

By default, MPLS is the delivery mechanism for the SDP and the SDP administrative state is disabled.

Platforms Supported

OmniSwitch 9000E

Usage Guidelines

Use the no form of this command to remove the specified SDP. Disable the administrative status and

remove any services associated with the SDP before attempting to remove the SDP.

Administratively enabling the SDP is not allowed until a far-end router address is configured for the

SDP. Specifying this address identifies the router on which the SDP will terminate. As a result, an SDP

tunnel is configured that will provide a path from Point A to Point B.

Configure an SDP on each participating provider edge (PE) router.

Once created, an SDP is then bound to a specific customer Virtual Private LAN Service (VPLS). This

binding process allows routers to participate in a service.

Binding multiple services to one SDP is allowed; up to 32 SDP sessions are allowed at the same time.

-> configure service sdp 10 create

-> configure service sdp 20 mpls create

-> configure service no sdp 20

Release History

Release 6.4.2; command was introduced.

OmniSwitch CLI Reference Guide

The identification number to associate with the specified SDP. The

valid ID range is 1–17407.

The delivery mechanism for the SDP. No other mechanism is supported

at this time.