Configure Service Vpls Sap Static-Mac - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

configure service vpls sap static-mac

Configures a static MAC address entry in the Virtual Private LAN Service (VPLS) forwarding database
(FDB) that is associated with the specified SAP ID. A SAP ID is comprised of a customer-facing port
(referred to as an access port) and an encapsulation value that is used to identify the type of customer traf-
fic to map to the associated service.
configure service vpls service-id sap {slot/port | linkagg agg_num} [:0 | :all | :qtag1] static-mac mac-
address
configure service vpls service-id sap {slot/port | linkagg agg_num} [:0 | :all | :qtag1] no static-mac mac-
address
Syntax Definitions
service-id
slot/port1
:0
:all
:qtag1
agg_num
mac-address
Defaults
parameter
:0 | :all | :qtag1
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
•
To specify a SAP ID, use the slot/port and linkagg agg-num parameters combined with the :0, :qtag,
or :all parameters. For example, enter 1/2:all to specify the SAP on access port 1/2 that maps all traffic
to this service that is not already mapped to other SAPs.
•
Use the no form of this command to remove the remote static MAC address entry from the VPLS
forwarding database.
page 50-68
An existing VPLS ID number.
The slot and port number of the service access port.
Specifies a null encapsulation value for the SAP. Depending on the pre-
configured encapsulation type for the access port, a SAP using a null
encapsulation will direct tagged and untagged or only untagged traffic to
the associated service.
Specifies a wildcard SAP. All tagged or untagged traffic that is not clas-
sified into another SAP is mapped to the wildcard SAP. Not config-
urable on null encapsulation access ports.
Specifies a VLAN ID tag for traffic ingressing on the access port. Only
traffic with this tag is mapped to this SAP. Not configurable on null
encapsulation access ports.
The link aggregate ID number (0–31) of a service access link aggregate.
A 48-bit MAC address (aa:bb:cc:dd:ee:ff). Valid addresses are any non-
broadcast, non-multicast MAC, and non-IEEE reserved addresses.
default
:0 (null)
Virtual Private LAN Service (VPLS) Commands
OmniSwitch CLI Reference Guide June 2012