Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 2759

Network Security Commands
-> show netsec group test1 anomaly arp-addr-scan config
Group
------------------------------+----------------+---+-+-+--+-----+-----+-----------
test1
output definitions
Group
Anomaly
S
L
T
Q
Per
Cnt
Sen
Release History
Release 6.3.1; command was introduced.
Related Commands
netsec group anomaly
show netsec operation
MIB Objects
alaNetSecMonitoringGroupConfig
alaNetSecMonitoringGroupName
alaNetSecMonitoringGroupAnomaly
alaNetSecMonitoringGroupAnomalyState
alaNetSecMonitoringGroupAnomalyLog
alaNetSecMonitoringGroupAnomalyTrap
alaNetSecMonitoringGroupAnomalyQuarantine
alaNetSecMonitoringGroupAnomalyCount
alaNetSecMonitoringGroupAnomalySensitivity
alaNetSecMonitoringGroupAnomalyPeriod
OmniSwitch CLI Reference Guide
Anomaly
arp-addr-scan
The name of the monitoring-group.
The anomaly type of the monitoring group.
The current state (- indicates Not configured, E indicates enabled, and
D indicates disabled).
Log (- indicates Not configured, E indicates enabled, and D indicates
disabled).
Trap (- indicates Not configured, E indicates enabled, and D indicates
disabled).
Quarantine (- indicates Not configured, E indicates enabled, and D
indicates disabled).
Anomaly monitoring period (- indicates Not configured)
Anomaly detection threshold (- indicates Not configured)
Anomaly sensitivity (- indicates Not configured)
Configures the monitoring period of an anomaly for a port-group,
packet count configuration for triggering anomaly detection, anomaly
detection algorithm's sensitivity to discrepancy in standard and
observed traffic pattern.
Displays the network security operational conditions at per port anom-
aly level.
June 2012
S L T Q Per Cnt
E E E - - -
Sen
-
page 38-17