Netsec Group Anomaly - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

netsec group anomaly

Configures various anomaly parameters of a monitoring-group and specifies the anomaly to monitor for
the monitoring-group.
netsec group {grp_name | all} anomaly {anomaly_name | all} {{{state | log | trap | quarantine} {enable |
disable}} | {period seconds} | {count num} | {sensitivity num}}
no netsec group grp_name anomaly {anomaly_name | all} {state | log | trap | quarantine | period |
count | sensitivity}
Syntax Definitions
grp_name
group all
anomaly_name
anomaly all
state
log
trap
quarantine
period seconds
count num
sensitivity num
enable
disable
page 38-4
The name of the monitoring-group (up to 32 characters).
Specifies all the monitoring-groups.
The type of the anomaly to be enabled or disabled. (Refer to the table in
the "Usage Guidelines" section below for a list of supported anomalies).
Monitors all anomalies.
Specifies the status of anomaly detection.
Logs detected anomalies.
Sends a trap when an anomaly is detected.
Quarantines the port on which an anomaly is detected.
The time duration to observe traffic pattern, in seconds. The valid range
is 5-3600
The number of packets that must be seen during the period to trigger
anomaly detection. The valid range is 1-100000.
Sensitivity of anomaly detection to deviation from the expected traffic
pattern. The valid range is 1-100.
Enables the status of the state, log, trap, and quarantine parameters for
the anomaly.
Disables the status of the state, log, trap, and quarantine parameters for
the anomaly.
Network Security Commands
OmniSwitch CLI Reference Guide June 2012