Vlan Ipx - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

vlan ipx

Defines an IPX network address rule for an existing VLAN. If a device sends traffic that matches the IPX
network address and encapsulation specified in the rule, the device and its mobile port will join the rule's
VLAN.
vlan vid ipx ipx_net [e2 | llc | snap | novell]
vlan vid no ipx ipx_net
Syntax Definitions
vid
ipx_net
e2
llc
snap
novell
Defaults
parameter
e2 | llc | snap | raw
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use the no form of this command to delete an IPX network address rule from the specified VLAN. It is
only necessary to enter the IPX network address to identify which rule to delete; the encapsulation is
not required.
•
Specify e2, llc, snap, or novell-raw to identify the IPX encapsulation the device is going to use. If
there is a mismatch and IPX traffic is routed, connectivity with the IPX server may not occur.
•
This rule only applies to those devices that already have an IPX network address configured with an
encapsulation that matches the encapsulation specified for the rule.
•
Network address rules take precedence behind DHCP, binding, and MAC address rules.
•
To remove an IPX network address rule, it is not necessary to specify the IPX encapsulation value.
•
Rules are only assigned to existing VLANs. Use the vlan command to create a new VLAN.
page 37-22
VLAN ID number (1–4094).
IPX network address consisting of up to eight hex characters
(e.g., A010590C, B030210A). If less than eight hex digits are entered,
the entry is prefixed with zeros to equal eight digits.
Enter e2 to specify Ethernet-II encapsulation.
LLC (802.2) encapsulation.
SNAP encapsulation.
Novell Raw (802.3) encapsulation.
default
e2
Port Mobility Commands
OmniSwitch CLI Reference Guide June 2012